149
Configure the Leave timer
garp timer leave timer-value
Optional
60 centiseconds by default
As shown in Table 19, the value ranges for GARP timers are dependent on one another; use the following
guidelines to configure GARP timers:
ï‚· If you want to set a value beyond the value range for a timer, you can change the value range by
tuning the value of another related timer.
ï‚· If you want to restore the default settings of the timers, restore the Hold timer first, followed by the
Join, Leave, and LeaveAll timers.
Table 19 Dependencies of GARP timers
No greater than half of the Join timer setting
No less than two times the Hold timer
setting
Less than half of the leave timer setting
Greater than two times the Join timer setting
Less than the LeaveAll timer setting
Greater than the Leave timer setting
Displaying and maintaining GVRP
Display statistics about GARP on
ports
display garp statistics [ interface
interface-list ] [ | { begin | exclude |
include } regular-expression ]
Display GARP timers on ports
display garp timer [ interface interface-
list ] [ | { begin | exclude | include }
regular-expression ]
Display the local VLAN information
that GVRP maintains on ports
display gvrp local-vlan interface
interface-type interface-number [ | {
begin | exclude | include } regular-
expression ]
Display the current GVRP state in the
specified VLANs on ports
display gvrp state interface interface-
type interface-number vlan vlan-id [ | {
begin | exclude | include } regular-
expression ]
Display GVRP statistics on ports
display gvrp statistics [ interface
interface-list ] [ | { begin | exclude |
include } regular-expression ]
Display the global GVRP state
display gvrp status [ | { begin | exclude
| include } regular-expression ]
Display the information about
dynamic VLAN operations on ports
display gvrp vlan-operation interface
interface-type interface-number [ | {
begin | exclude | include } regular-
expression ]
To Next Page
Loading...
