38
Set the system LACP priority
lacp system-priority system-priority
Optional
By default, the system LACP
priority is 32768.
Changing the system LACP
priority might affect the
aggregation state of the ports in a
dynamic aggregation group.
Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view
interface bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Configure the aggregation group
to work in dynamic aggregation
mode
link-aggregation mode dynamic
Required
By default, an aggregation group
works in static aggregation mode.
Enter Layer 2 Ethernet interface
view
interface interface-type interface-
number
Required
Repeat these two steps to assign
more Layer 2 Ethernet interfaces
to the aggregation group.
Assign the Ethernet interface to
the aggregation group
port link-aggregation group
number
Assign the port an LACP priority
lacp port-priority port-priority
Optional
By default, the LACP priority of a
port is 32768.
Changing the LACP priority of a
port might affect the aggregation
state of the ports in the dynamic
aggregation group.
Set the LACP timeout interval on
the port to the short timeout
interval (1 second)
Optional
By default, the LACP timeout
interval on a port is the long
timeout interval (30 seconds).
Configuring an aggregate interface
You can perform the following configurations on an aggregate interface:
Configuring the description of an aggregate interface
Enabling link state traps for an aggregate interface
Shutting down an aggregate interface
NOTE:
Most of the configurations that can be performed on Layer 2 Ethernet interfaces can also be performed
on Layer 2 aggregate interfaces.
To Next Page
Loading...
Need help?
General
