HP A5120 EI Series Configuration Guide

119
To do…
Use the command…
Remarks
Create a protocol template for the
VLAN
protocol-vlan [ protocol-index ] {
at | ipv4 | ipv6 | ipx { ethernetii
| llc | raw | snap } | mode {
ethernetii etype etype-id | llc {
dsap dsap-id [ ssap ssap-id ] |
ssap ssap-id } | snap etype
etype-id } }
Required
Exit VLAN view
quit
Required
Enter interface
view or port
group view
Enter Ethernet
interface view
interface interface-type interface-
number
Required
Use either command.
 In Ethernet interface view,
the subsequent
configurations apply to the
current port.
 In port group view, the
subsequent configurations
apply to all ports in the port
group.
 In Layer 2 aggregate
interface view, the
subsequent configurations
apply to the Layer 2
aggregate interface and all
its member ports.
Enter Layer 2
aggregate
interface view
interface bridge-aggregation
interface-number
Enter port group
view
port-group manual port-group-
name
Configure the port link type as hybrid
port link-type hybrid
Required
Configure current hybrid port(s) to
permit the packets of the specified
protocol-based VLANs to pass
through
port hybrid vlan vlan-id-list {
tagged | untagged }
Required
By default, all hybrid ports
permit only packets of VLAN 1
to pass through.
Associate the hybrid port(s) with the
specified protocol-based VLAN
port hybrid protocol-vlan vlan
vlan-id { protocol-index [ to
protocol-end ] | all }
Required

HP A5120 EI Series Specifications

General

Uplink Ports	4 x SFP
Stacking	No
Management	CLI, Web, SNMP
Routing Protocols	RIP, OSPF
Power Supply	AC
MAC Address Table Size	16K
Dimensions	440 x 430 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% non-condensing
Model	HP A5120-24G EI Switch (JG234A)
VLANs	4094