HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Guide

Configuration Commands 103
Table 105 CIST Bridge Configuration commands
Command Description
show spanning-tree mstp cist
Displays the current CIST bridge configuration.
Command mode: All
CIST port configuration
CIST port parameters are used to modify MRST operation on an individual port basis. CIST parameters do not affect
operation of STP/PVST.
For each port, CIST is turned on by default. Port parameters include:
• Port priority
• Port path cost
• Port Hello time
• Link type
• Edge
• On and off
• Current port configuration
The port option of MRST is turned on by default.
The following table describes the commands used to configure CIST Port Configuration commands.
Table 106 CIST Port Configuration commands
Command Description
spanning-tree mstp cist
interface-priority {<0-240>}
Configures the CIST port priority. The port priority helps determine which
bridge port becomes the designated port. In a network topology that has
multiple bridge ports connected to a single segment, the port with the
lowest port priority becomes the designated port for the segment. The
range is 0 to 240, in steps of 16 (0, 16, 32...), and the default is 128.
Command mode: Interface port
spanning-tree mstp cist path-
cost {<1-200000000>}
Configures the CIST port path cost. The port path cost is used to help
determine the designated port for a segment. Generally speaking, the
faster the port, the lower the path cost. The default is 20000 for Gigabit
ports.
Command mode: Interface port
spanning-tree mstp cist hello
{<1-10>}
Configures the CIST port Hello time. The Hello time specifies how often
the root bridge transmits a configuration bridge protocol data unit
(BPDU). Any bridge that is not the root bridge uses the root bridge Hello
value. The range is 1 to 10 seconds, and the default is 2 seconds.
Command mode: Interface port
spanning-tree mstp cist link-
type {auto|p2p|shared}
Defines the type of link connected to the port, as follows:
auto: Configures the port to detect the link type, and automatically match
its settings.
p2p: Configures the port for Point-To-Point protocol.
shared: Configures the port to connect to a shared medium (usually a
hub).
The default link type is auto.
Command mode: Interface port
[no] spanning-tree mst cist edge
Enables or disables this port as an edge port. An edge port is not
connected to a bridge, and can begin forwarding traffic as soon as the
link is up. Configure server ports as edge ports (enabled). This command
is disabled by default.
Command mode: Interface port
spanning-tree mst cist enable
Enables CIST on the port.
Command mode: Interface port
no spanning-tree mst cist enable
Disables CIST on the port.
Command mode: Interface port

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English