HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Guide

Information Commands 16
Information Commands
Introduction
You can view configuration information for the switch in the ISCLI. This chapter discusses how to use the ISCLI to
display switch information.
The following table describes general information commands.
Table 5 Information commands
Command Usage
show sys-info Displays system information.
Command mode: All
show layer2 information Displays Layer 2 information.
Command mode: All
show layer3 information Displays Layer 3 information.
Command mode: All
show rmon Displays Remote Monitoring Information.
Command mode: All
show interface link Displays configuration information about each port, including:
• Port number
• Port speed (10 Mb/s, 100 Mb/s, 1000 Mb/s, or any)
• Duplex mode (half, full, or any)
• Flow control for transmit and receive (no, yes, or any)
• Link status (up or down)
Command mode: All except User EXEC
show interface information Displays port status information, including:
• Port number
• Whether the port uses VLAN tagging or not
• Port VLAN ID (PVID)
• Port name
• VLAN membership
Command mode: All except User EXEC
show geaport Displays GEA port mapping information, used by service personnel.
Command mode: All
show ufd Displays Uplink Failure Detection information.
Command mode: All
show information-dump Dumps all switch information available (10K or more, depending on your
configuration).
If you want to capture dump data to a file, set your communication software
on your workstation to capture session data prior to issuing the dump
commands.
Command mode: All

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English