HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Guide

Configuration Commands 93
Table 89 SNMPv3 Target Parameters Table Configuration commands
Command Description
snmp-server target-parameters
<1-16> level {noAuthNo-
Priv|authNoPriv|authPriv}
Selects the level of security to be used when generating the SNMP messages
using this entry. The level
noAuthNoPriv means that the SNMP message
will be sent without authentication and without using a privacy protocol. The
level
authNoPriv means that the SNMP message will be sent with
authentication but without using a privacy protocol. The
authPriv means
that the SNMP message will be sent both with authentication and using a
privacy protocol.
Command mode: Global configuration
no snmp-server target-
parameters <1-16>
Deletes the targetParamsTable entry.
Command mode: Global configuration
show snmp-server target-
parameters <1-16>
Displays the current targetParamsTable configuration.
Command mode: All
SNMPv3 Notify Table configuration
SNMPv3 uses Notification Originator to send out traps. A notification typically monitors a system for particular events
or conditions, and generates Notification-Class messages based on these events or conditions.
The following table describes the SNMPv3 Notify Table Configuration commands.
Table 90 SNMPv3 Notify Table Configuration commands
Command Description
snmp-server notify <1-16>
name <1-32 characters>
Defines a locally arbitrary but unique identifier associated with this SNMP notify
entry.
Command mode: Global configuration
snmp-server notify <1-16>
tag <1-255 characters>
Defines a tag of 255 characters maximum that contains a tag value which is used
to select entries in the Target Address Table. Any entry in the
snmpTargetAddrTable, that matches the value of this tag, is selected.
Command mode: Global configuration
no snmp-server notify <1-
16>
Deletes the notify table entry.
Command mode: Global configuration
show snmp-server notify
<1-16>
Displays the current notify table configuration.
Command mode: All
System Access configuration
The following table describes the System Access Configuration commands.
Table 91 System Access Configuration commands
Command Description
[no] access http enable
Enables or disables HTTP (Web) access to the Browser-based Interface. It is
enabled by default.
Command mode: Global configuration
access http port <TCP port
number>
Sets the switch port used for serving switch Web content. The default is HTTP
port 80.
Command mode: Global configuration
[no] access snmp {read-only|
read-write}
Disables or provides read-only/write-read SNMP access.
Command mode: Global configuration
access telnet port <TCP port
number>
Sets an optional telnet server port number for cases where the server listens for
telnet sessions on a non-standard port.
Command mode: Global configuration
[no] access telnet enable
Enables or disables Telnet access.
Command mode: Global configuration

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English