HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Guide

Configuration Commands 87
Table 80 NTP Server Configuration commands
Command Description
ntp timezone <hh:mm>
Configures the NTP time zone offset from Greenwich Mean Time (GMT),
in hours and minutes. The offset format is HH:MM.
Command mode: Global configuration
[no] ntp daylightsavings
Disables or enables daylight saving time in the system clock. When
enabled, the switch will add an extra hour to the system clock so that it
is consistent with the local clock. By default, this option is disabled.
Command mode: Global configuration
ntp enable
Enables the NTP synchronization service.
Command mode: Global configuration
no ntp enable
Disables the NTP synchronization service. This is the default.
Command mode: Global configuration
show ntp
Displays the current NTP service settings.
Command mode: All
System SNMP configuration
The switch software supports SNMP-based network management. In SNMP model of network management, a
management station (client/manager) accesses a set of variables known as MIBs (Management Information Base)
provided by the managed device (agent). If you are running an SNMP network management station on your network,
you can manage the switch using the following standard SNMP MIBs:
• MIB II (RFC 1213)
• Ethernet MIB (RFC 1643)
• Bridge MIB (RFC 1493)
An SNMP agent is a software process on the managed device that listens on UDP port 161 for SNMP messages.
Each SNMP message sent to the agent contains a list of management objects to retrieve or to modify.
• SNMP parameters that can be modified include:
• System name
• System location
• System contact
• Use of the SNMP system authentication trap function
• Read community string
• Write community string
The following table describes the System SNMP Configuration commands. The following sections provide more
detailed information and commands.
Table 81 System SNMP Configuration commands
Command Description
hostname <1-64
characters>
Configures the name for the system. The name can have a maximum of 64 characters.
Command mode: Global configuration
snmp-server location
<1-64 characters>
Configures the name of the system location. The location can have a maximum of 64
characters.
Command mode: Global configuration
snmp-server contact <1-
64 characters>
Configures the name of the system contact. The contact can have a maximum of 64
characters.
Command mode: Global configuration
snmp-server read-
community <1-32
characters>
Configures the SNMP read community string. The read community string controls SNMP
“get” access to the switch. It can have a maximum of 32 characters. The default read
community string is public.
Command mode: Global configuration

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English