Information Commands 28
Show all FDB information
The following command displays Forwarding Database information:
show mac-address-table
Command mode: All
MAC address VLAN Port Trnk State
----------------- ---- ---- ---- -----
00:02:01:00:00:00 300 1 TRK
00:02:01:00:00:01 300 23 FWD
00:02:01:00:00:02 300 23 FWD
00:02:01:00:00:03 300 23 FWD
00:02:01:00:00:04 300 23 FWD
00:02:01:00:00:05 300 23 FWD
00:02:01:00:00:06 300 23 FWD
00:02:01:00:00:07 300 23 FWD
00:02:01:00:00:08 300 23 FWD
00:02:01:00:00:09 300 23 FWD
00:02:01:00:00:0a 300 23 FWD
00:02:01:00:00:0b 300 23 FWD
00:02:01:00:00:0c 300 23 FWD
An address that is in the forwarding (FWD) state indicates that the switch has learned it. When in the trunking (TRK)
state, the Trnk field displays the trunk group number. If the state for the port is listed as unknown (UNK), the MAC
address has not yet been learned by the switch, but has only been seen as a destination address. When an address
is in the unknown state, no outbound port is indicated.
Clearing entries from the forwarding database
To delete a static MAC address from the forwarding database (FDB), see the “Static FDB configuration” section in the
“Configuration Commands” chapter.
Link Aggregation Control Protocol information
The following table describes the Link Aggregation Control Protocol information commands.
Table 19 LACP information commands
Command Usage
show interface port <port number> lacp
aggregator
Displays LACP aggregator information for the port.
Command mode: All
show lacp
Displays LACP information for the port.
Command mode: All
show lacp information
Displays all LACP information parameters.
Command mode: All
To Next Page
Loading...
