HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Guide

Configuration Commands 97
Table 96 Port Configuration commands
Command Description
shutdown
Disables the port. To temporarily disable a port without changing its
configuration attributes, see the “Temporarily disabling a port” section later in
this chapter.
Command mode: Interface port
show interface port {<port
number>}
Displays current port parameters.
Command mode: All
Temporarily disabling a port
To temporarily disable a port without changing its stored configuration attributes, enter the following command at any
prompt:
Switch# interface port <port number> shutdown
Because this configuration sets a temporary state for the port, you do not need to perform a save operation. The port
state reverts to its original configuration when the switch is reloaded.
Port link configuration
Use these commands to set port parameters for the port link.
Link commands are described in the following table. Using these commands, you can set port parameters such as
speed, duplex, flow control, and negotiation mode for the port link.
The following table describes the Gigabit Link Configuration commands.
Table 97 Gigabit Link Configuration commands
Command Description
speed {10|100|1000|auto}
Sets the link speed. Not all options are valid on all ports. The choices include:
• 10 Mb/s
• 100 Mb/s
• 1000 Mb/s
• “auto,” for automatic detection (default)
Note: Ports 1-18 are set to 1000 Mb/s, and cannot be changed.
Command mode: Interface port
duplex {full|half|any}
Sets the operating mode. Not all options are valid on all ports. The choices
include:
• Full-duplex
• Half-duplex
• “Any,” for automatic detection (default)
Note: Ports 1-18 are set to full duplex, and cannot be changed.
Command mode: Interface port
flowcontrol
{receive|send|both}
Sets the flow control. The choices include:
• Receive (rx) flow control
• Transmit (tx) flow control
• Both receive and transmit flow control (default)
Command mode: Interface port
no flowcontrol
Sets the flow control to none.
Command mode: Interface port
[no] auto Enables or disables auto-negotiation for the port.
Command mode: Interface port
show interface port {<port
number>}
Displays current port parameters.
Command mode: All

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English