To Next Page

To Previous Page

Statistics commands 55

Statistics commands

Introduction

You can view switch performance statistics in the user, operator, and administrator command modes. This chapter

discusses how to use the ISCLI to display switch statistics.

The following table describes general Statistics commands.

Table 43 Statistics commands

Command Usage

show layer2 counters

Displays Layer 2 Statistics.

Command mode: All

show layer3 counters

Displays Layer 3 Statistics.

Command mode: All

NOTE: Layer 3 commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.

show snmp-server counters

Displays SNMP statistics.

Command mode: All

show ntp counters

Displays Network Time Protocol (NTP) Statistics.

You can execute the clear command option to delete all statistics.

Command mode: All

clear ntp

Clears Network Time Protocol (NTP) Statistics.

Command mode: All

show ufd counters

Displays Uplink Failure Detection statistics.

Command mode: All

show counters

Dumps all switch statistics. Use this command to gather data for

tuning and debugging switch performance. If you want to capture

dump data to a file, set your communication software on your

workstation to capture session data prior to issuing the dump

command.

Command mode: All

Port Statistics

The following table describes the Port Statistics commands. The following sections provide more detailed information

and commands.

Table 44 Port Statistics commands

Command Usage