Information Commands 45
RIP user configuration
NOTE: RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following command displays RIP user information:
show interface ip [<1-256>] rip
Command mode: All
RIP USER CONFIGURATION :
RIP on updat 30
RIP Interface 2 : 102.1.1.1, enabled
version 2, listen enabled, supply enabled, default none
poison disabled, trigg enabled, mcast enabled, metric 1
auth none,key none
RIP Interface 3 : 103.1.1.1, enabled
version 2, listen enabled, supply enabled, default none
poison disabled, trigg enabled, mcast enabled, metric 1
IP information
NOTE: Layer 3 commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following command displays Layer 3 information:
show layer3 information
Command mode: All
Interface information:
1: 47.80.23.243 255.255.254.0 47.80.23.255, vlan 1, up
Default gateway information: metric strict
1: 47.80.22.1, up
2: 47.80.225.2, up
The following interface and default gateway information is displayed:
• Interface number
• IP address
• IP mask
• IP broadcast address
• Operational status
IGMP multicast group information
The following table describes the commands used to display information about IGMP groups learned by the switch.
Table 35 IGMP Multicast Group commands
Command Usage
show ip igmp groups
address <IP address>
Displays a single IGMP multicast group by its IP address.
Command mode: All except User EXEC
show ip igmp groups
vlan <1-4095>
Displays all IGMP multicast groups on a single VLAN.
Command mode: All except User EXEC
show ip igmp groups
interface <port number>
Displays all IGMP multicast groups on a single port.
Command mode: All except User EXEC
show ip igmp groups
trunk <1-12>
Displays all IGMP multicast groups on a single trunk group.
Command mode: All except User EXEC
show ip igmp groups
Displays information for all multicast groups.
Command mode: All except User EXEC
To Next Page
Loading...
Need help?
General