Configuration Commands 98
ACL Port configuration
The following table describes the basic Access Control List Configuration commands for the port.
Table 98 ACL Port Configuration commands
Command Description
[no] access-control list <1-762>
Adds or removes the specified ACL.
Command mode: Interface port
[no] access-control group <1-762>
Adds or removes the specified ACL Group.
Command mode: Interface port
show interface port [<port number>]
access-control
Displays current ACL QoS parameters.
Command mode: All
Layer 2 configuration
The following table describes the Layer 2 Configuration commands. The following sections provide more detailed
information and commands.
Table 99 Layer 2 Configuration commands
Command Description
vlan {<1-4095>}
Enter VLAN configuration mode.
Command mode: Global configuration
[no] spanning-tree
uplinkfast
Enables or disables Fast Uplink Convergence, which provides rapid Spanning
Tree convergence to an upstream switch during failover.
Note: When enabled, this feature increases bridge priorities to 65500 for all
STGs and path cost by 3000 for all external STP ports.
Command mode: Global configuration
spanning-tree uplinkfast
max-update-rate <10-200>
Configures the station update rate, in packets per second.
The range is 10-200. The default value is 40.
Command mode: Global configuration
show layer2
Displays current Layer 2 parameters.
Command mode: All
802.1x configuration
This feature allows you to configure the GbE2c as an IEEE 802.1x Authenticator, to provide port-based network
access control. The following table describes the 802.1x Configuration commands.
Table 100 802.1x Configuration commands
Command Description
dot1x enable
Globally enables 802.1x.
Command mode: Global configuration
no dot1x enable
Globally disables 802.1x.
Command mode: Global configuration
show dot1x
Displays current 802.1x parameters.
Command mode: All
To Next Page
Loading...
