Information Commands 41
ARP address list information
The following command displays ARP address list information:
show ip arp reply
Command mode: All except User EXEC
IP address IP mask MAC address VLAN Flags
--------------- --------------- ----------------- ---- -----
205.178.18.66 255.255.255.255 00:70:cf:03:20:04 P
205.178.50.1 255.255.255.255 00:70:cf:03:20:06 1
205.178.18.64 255.255.255.255 00:70:cf:03:20:05 1
This screen displays all entries in the ARP cache.
OSPF information
NOTE: OSPF commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the OSPF commands.
Table 32 OSPF information commands
Command Usage
show ip ospf general-information
Displays general OSPF information.
Command mode: All except User EXEC
show ip ospf area information [<0-2>]
Displays area information for a particular area index. If no
parameter is supplied, it displays area information for all the
areas.
Command mode: All except User EXEC
show ip ospf interface [<1-256>]
Displays interface information for a particular interface. If no
parameter is supplied, it displays information for all the
interfaces.
Command mode: All except User EXEC
show ip ospf area-virtual-link
information
Displays information about all the configured virtual links.
Command mode: All except User EXEC
show ip ospf neighbor
Displays the status of all the current neighbors.
Command mode: All except User EXEC
show ip ospf summary-range <0-2>
Displays the list of summary ranges belonging to non-NSSA
areas.
Command mode: All except User EXEC
show ip ospf summary-range-nssa <0-2>
Displays the list of summary ranges belonging to NSSA areas.
Command mode: All except User EXEC
show ip ospf routes
Displays OSPF routing table.
Command mode: All except User EXEC
show ip ospf information
Displays the OSPF information.
Command mode: All except User EXEC
To Next Page
Loading...
