Information Commands 17
System Information commands
The following table describes the System Information commands.
Table 6 System Information commands
Command Usage
show snmp-server v3
Displays SNMP v3 information.
Command mode: All
show sys-info
Displays system information, including:
• System date and time
• Switch model name and number
• Switch name and location
• Time of last boot
• MAC address of the switch management processor
• IP address of IP interface #1
• Hardware version and part number
• Software image file and version number
• Configuration name
• Log-in banner, if one is configured
Command mode: All
show logging messages
Displays most recent syslog messages.
Command mode: All
show access user
Displays User Access information.
Command mode: All except User EXEC
SNMPv3 Information commands
SNMP version 3 (SNMPv3) is an extensible SNMP Framework that supplements the SNMPv2 Framework by
supporting the following:
• a new SNMP message format
• security for messages
• access control
• remote configuration of SNMP parameters
For more details on the SNMPv3 architecture, see RFC2271 to RFC2276.
The following table describes the SNMPv3 Information commands.
Table 7 SNMPv3 Information commands
Command Usage
show snmp-server v3 user
Displays User Security Model (USM) table information.
Command mode: All
show snmp-server v3 view
Displays information about view name, subtrees, mask and
type of view.
Command mode: All
show snmp-server v3 access
Displays View-based Access Control information.
Command mode: All
show snmp-server v3 group
Displays information about the group that includes the security
model, user name, and group name.
Command mode: All
show snmp-server v3 community
Displays information about the community table.
Command mode: All
show snmp-server v3 target-address
Displays the Target Address table.
Command mode: All
show snmp-server v3 target-parameters
Displays the Target parameters table.
Command mode: All
To Next Page
Loading...
