HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Guide

Configuration Commands 88
Table 81 System SNMP Configuration commands
Command Description
snmp-server write-
community <1-32
characters>
Configures the SNMP write community string. The write community string controls SNMP
“set” and “get” access to the switch. It can have a maximum of 32 characters. The
default write community string is private.
Command mode: Global configuration
snmp-server timeout <1-
30>
Sets the timeout value for the SNMP state machine. The range is 1-30 minutes. The
default value is 5 minutes.
Command mode: Global configuration
[no] snmp-server
authentication-trap
enable
Enables or disables the use of the system authentication trap facility. The default setting
is disabled.
Command mode: Global configuration
[no] snmp-server link-
trap
Enables or disables the sending of SNMP link up and link down traps. The default
setting is enabled.
Command mode: Global configuration
[no] snmp-server ufd-
trap
Enables or disables the sending of Uplink Failure Detection traps. The default setting is
disabled.
Command mode: Global configuration
show snmp-server
Displays the current SNMP configuration.
Command mode: All
SNMPv3 configuration
SNMP version 3 (SNMPv3) is an extensible SNMP Framework that supplements the SNMPv2 Framework by
supporting the following:
• a new SNMP message format
• security for messages
• access control
• remote configuration of SNMP parameters
For more details on the SNMPv3 architecture please see RFC2271 to RFC2275.
The following table describes the SNMPv3 Configuration commands.
Table 82 SNMPv3 Configuration commands
Command Description
snmp-server user <1-16>
Configures a user security model (USM) entry for an authorized user. You can also
configure this entry through SNMP. The range is 1-16.
Command mode: Global configuration
snmp-server view <1-128>
Configures different MIB views. The range is 1-128.
Command mode: Global configuration
snmp-server access <1-32>
Configures access rights. The View-based Access Control Model defines a set of
services that an application can use for checking access rights of the user. You need
access control when you have to process retrieval or modification request from an
SNMP entity. The range is 1-32.
Command mode: Global configuration
snmp-server group <1-16>
Configures an SNMP group. A group maps the user name to the access group
names and their access rights needed to access SNMP management objects. A
group defines the access rights assigned to all names that belong to a particular
group. The range is 1-16.
Command mode: Global configuration
snmp-server community <1-
16>
Configures a community table entry. The community table contains objects for
mapping community strings and version-independent SNMP message parameters.
The range is 1-16.
Command mode: Global configuration

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English