HP GbE2c - Blc Layer 2/3 Fiber SFP Option - ACL Metering Configuration; ACL Re-Mark Configuration; ACL Re-Mark In-Profile Configuration

Configuration Commands 134
ACL Metering configuration
The following table describes the ACL Metering Configuration commands.
Table 158 ACL Metering Configuration commands
Command Description
access-control list <1-762>
meter committed-rate <64-
1000000>
Configures the committed rate, in Kilobits per second. The committed rate must
be a multiple of 64.
Command mode: Global configuration
access-control list <1-762>
meter maximum-burst-size
<32-4096>
Configures the maximum burst size, in Kilobits. Enter one of the following
values for
mbsize: 32, 64, 128, 256, 512, 1024, 2048, 4096
Command mode: Global configuration
[no] access-control list <1-
762> meter enable
Enables or disables Metering on the ACL.
Command mode: Global configuration
access-control list <1-762>
meter action {drop|pass}
Configures the ACL Meter to either drop or pass out-of-profile traffic.
Command mode: Global configuration
default access-control list
<1-762> meter
Reset ACL Metering parameters to their default values.
Command mode: Global configuration
show access-control list <1-
762> meter
Displays the current ACL metering parameters.
Command mode: All except User EXEC
ACL Re-mark configuration
You can choose to re-mark IP header data for the selected ACL. You can configure different re-mark values, based on
whether packets fall within the ACL Metering profile, or out of the ACL Metering profile.
The following table describes the ACL Re-mark Configuration commands.
Table 159 ACL Re-mark Configuration commands
Command Description
[no] access-control list <1-762>
re-mark
Assign an ACL for DSCP Re-marking.
Command mode: Global configuration
default access-control list <1-762>
re-mark
Reset ACL Re-mark parameters to their default values.
Command mode: Global configuration
show access-control list <1-762>
re-mark
Displays the current ACL re-mark parameters.
Command mode: All except User EXEC
ACL Re-mark In-Profile configuration
The following table describes the ACL Re-mark In-Profile Configuration commands.
Table 160 ACL Re-mark In-Profile Configuration commands
Command Description
access-control list <1-762>
re-mark in-profile dscp <0-63>
Sets the DiffServ Code Point (DSCP) of In-Profile packets to the selected
value.
Command mode: Global configuration
default access-control list
<1-762> re-mark
Resets the update DSCP parameters to their default values.
Command mode: Global configuration
show access-control list <1-
762> re-mark
Displays the current ACL re-mark parameters.
Command mode: All except User EXEC