Information Commands 54
Uplink Failure Detection (UFD) information includes:
• UFD status, either enabled or disabled
• LtM status and member ports
• Spanning Tree status for LtM ports
• LtD status and member ports
Information dump
The following command dumps switch information:
show information-dump
Command mode: All
Use the dump command to dump all switch information available from GbE2c memory (10K or more, depending on
your configuration). This data is useful for tuning and debugging switch performance.
If you want to capture dump data to a file, set the communication software on your workstation to capture session
data prior to issuing the dump commands.
To Next Page
Loading...
