HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Guide

Configuration Commands 117
RIP Route Redistribution configuration
NOTE: RIP commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the RIP Route Redistribute commands.
Table 129 RIP Redistribute commands
Command Description
redistribute
{fixed|static|ospf|eospf}
<1-32>
Adds selected routing maps to the RIP route redistribution list. This option adds
a route map to the route redistribution list. The routes of the redistribution
protocol matched by the route maps in the route redistribution list will be
redistributed.
Command mode: Router RIP
no redistribute
{fixed|static|ospf|eospf}
<1-32>
Removes the route map from the RIP route redistribution list.
Command mode: Router RIP
redistribute
{fixed|static|ospf|eospf}
export metric <1-15>
Exports the routes of this protocol in which the metric and metric type are
specified. To remove a previous configuration and stop exporting the routes of
the protocol, enter
none.
Command mode: Router RIP
show ip rip redistribute
Displays the current RIP route redistribute configuration.
Command mode: Router RIP
Open Shortest Path First configuration
NOTE: OSPF commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the basic Open Shortest Path First (OSPF) commands. The following sections provide
more detailed information and commands.
Table 130 OSPF Configuration commands
Command Description
router ospf
Enter Router OSPF configuration mode.
Command mode: Router OSPF
area <0-2>
Configures the OSPF area.
Command mode: Router OSPF
area-range <0-16>
Configures the summary range.
Command mode: Router OSPF
ip ospf <1-256)>
Configures the OSPF interface.
Command mode: Interface IP
area-virtual-link <1-3>
Configures a Virtual Link.
Command mode: Router OSPF
message-digest-key <1-255> md5-
key <key string>
Assigns a string to MD5 authentication key.
Command mode: Router OSPF
host <1-128>
Configures an OSPF host route. Up to 128 host routes can be
configured. Host routes are used for advertising network device IP
addresses to external networks to perform server load balancing within
OSPF. It also makes Area Border Route (ABR) load sharing and ABR
failover possible.
Command mode: Router OSPF
lsdb-limit <0-2000>
Sets the link state database limit.
Command mode: Router OSPF
[no] default-information <1-
16777215> <as-value>
Sets one default route among multiple choices in an area.
Command mode: Router OSPF

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English