HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Guide

Configuration Commands 84
Table 77 SSHD Configuration commands
Command Description
ssh generate-server-key
Generates the RSA server key. The switch creates this key automatically while
configuring the switch with Secure Shell (SSH). You can generate the key manually
by using this command if you need to overwrite the key for security reasons. The
command will take effect immediately.
Command mode: Global configuration
ssh port <TCP port number>
Sets the SSH server port number.
Command mode: Global configuration
ssh scp-enable
Enables the SCP apply and save.
Command mode: Global configuration
no ssh scp-enable
Disables the SCP apply and save. This is the default for SCP.
Command mode: Global configuration
ssh enable
Enables the SSH server.
Command mode: Global configuration
no ssh enable
Disables the SSH server. This is the default for the SSH server.
Command mode: Global configuration
show ssh
Displays the current SSH server configuration.
Command mode: All
RADIUS server configuration
NOTE: See the HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Application Guide for information on
RADIUS.
The following table describes the RADIUS Server Configuration commands.
Table 78 RADIUS Server Configuration commands
Command Description
[no] radius-server primary-host
<IP address> key <1-32
characters>
Sets the primary RADIUS server address and shared secret between the
switch and the RADIUS server(s).
Command mode: Global configuration
[no] radius-server secondary-
host <IP address> key <1-32
characters>
Sets the secondary RADIUS server address and shared secret between the
switch and the RADIUS server(s).
Command mode: Global configuration
radius-server port <UDP port
number>
Enter the number of the User Datagram Protocol (UDP) port to be
configured, between 1500-3000. The default is 1645.
Command mode: Global configuration
radius-server retransmit <1-3>
Sets the number of failed authentication requests before switching to a
different RADIUS server. The range is 1-3 requests. The default is 3
requests.
Command mode: Global configuration
radius-server timeout <1-10>
Sets the amount of time, in seconds, before a RADIUS server
authentication attempt is considered to have failed. The range is 1-10
seconds. The default is 3 seconds.
Command mode: Global configuration
[no] radius-server telnet-
backdoor
Enables or disables the RADIUS back door for telnet/SSH/ HTTP/HTTPS.
This command does not apply when secure backdoor is enabled.
Command mode: Global configuration
[no] radius-server secure-
backdoor
Enables or disables the RADIUS back door using secure password for
telnet/SSH/ HTTP/HTTPS. This command does not apply when backdoor
(telnet) is enabled.
Command mode: Global configuration

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English