HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Guide

Configuration Commands 112
IP Static Route configuration
NOTE: These commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the Static Route Configuration commands.
Table 120 Static Route Configuration commands
Command Description
ip route <IP subnet> <IP
netmask> <IP nexthop> [<IP
interface (1-256)>]
Adds a static route. You will be prompted to enter a destination IP
address, destination subnet mask, and gateway address. Enter all
addresses using dotted decimal notation.
Command mode: Global configuration
no ip route {<IP subnet>}{<IP
netmask>}
Removes a static route. The destination address of the route to remove
must be specified using dotted decimal notation.
Command mode: Global configuration
show ip route static
Displays the current IPstatic route configuration.
Command mode: All except User Exec
Address Resolution Protocol configuration
Address Resolution Protocol (ARP) is the TCP/IP protocol that resides within the Internet layer. ARP resolves a physical
address from an IP address. ARP queries machines on the local network for their physical addresses. ARP also
maintains IP to physical address pairs in its cache memory. In any IP communication, the ARP cache is consulted to
see if the IP address of the computer or the router is present in the ARP cache. Then the corresponding physical
address is used to send a packet.
The following table describes the ARP Configuration commands.
Table 121 ARP Configuration commands
Command Description
ip arp rearp <2-120>
Defines re-ARP period in minutes. You can set this duration between 2 and 120
minutes.
show ip arp
Displays the current ARP configurations.
Command mode: All except User EXEC
IP Forwarding configuration
NOTE: IP Forwarding commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the IP Forwarding Configuration commands.
Table 122 IP Forwarding Configuration commands
Command Description
[no] ip routing direct-
broadcasts
Enables or disables forwarding directed broadcasts. This command is disabled
by default.
Command mode: Global configuration
ip routing
Enables IP forwarding (routing) on the GbE2c.
Command mode: Global configuration
no ip routing
Disables IP forwarding (routing) on the GbE2c. Forwarding is turned off by
default.
Command mode: Global configuration
show ip routing
Displays the current IP forwarding settings.
Command mode: All except User EXEC

HP GbE2c - Blc Layer 2/3 Fiber SFP Option Specifications

General

Brand	HP
Model	GbE2c - Blc Layer 2/3 Fiber SFP Option
Category	Switch
Language	English