Removing a Cache Module
CAUTION: To avoid bending the controller board, only remove or replace the cache module
when it is installed in the server blade.
To remove a cache module:
1. If the BBWC battery will also be removed:
a. Back up all data.
b. Close all applications.
2. Power of the server blade and remove it from the enclosure.
See “Preparing the Server Blade for Servicing” (page 110).
3. Remove the access panel.
See “Removing the Server Blade Access Panel” (page 112).
4. Remove any mezzanine cards blocking the cache module.
See “Removing a Mezzanine Card” (page 123).
5. Pull straight up on the cache module to remove it from the controller.
Figure 53 Removing the Cache Module
CAUTION: The BBWC battery must remain connected to the cache module to preserve the
data when removing the cache module to transfer data.
Removing and Replacing a Cache Module 125
To Next Page
Loading...
Need help?
General