4. To set the parameters, click OK.
5. If running an emulator, launch it now.
6. This ends the “Accessing the iLO 2 MP with No Network Connection” procedure.
7. Continue with “Configuring the iLO 2 MP” (page 44).
Configuring the iLO 2 MP
Use this procedure to configure iLO 2 MP settings after establishing a connection to iLO 2 MP
using one of the two methods discussed in Section : “Accessing the Integrated Lights Out 2
Management Processor”. This section includes important security considerations when configuring
your server blade for remote access.
Accessing iLO 2 MP After Establishing a Connection to the Server Blade
Depending on how you connect to the server blade, choose one of the following ways to access
the iLO 2 MP:
• Network connection (through OA iLO port)
1. From a network-accessible computer, open a telnet session.
2. Enter the iLO 2 MP address obtained in“Accessing the Integrated Lights Out 2 Management
Processor” (page 40) in the appropriate screen.
You now have access to the iLO 2 MP functionality through the telnet session.
• Serial port connection
• Ensure you have an MP prompt.
• Log in to the iLO 2 MP by using the following default values for the login ID and password
(case sensitive):
Login: Admin
Password: Admin
You are now at the MP Main Menu screen.
44 Installing the Server Blade Into the Enclosure
To Next Page
Loading...
Need help?
General