HP Integrity BL860c User Manual

3. To determine the current version of the firmware:
a. At the EFI Shell, enter mptutil from the directory that contains mptutil.efi.
The following example indicates that the EFI Serial Attached SCSI card utility version is
1.01.12.00:
fs0:EFI\HP\TOOLS\NETWORK> mptutil
MPTUTIL-1.01.12.00
Vendor Device
Choice ID ID Bus Device
------ ------ ------ --- ------
0 1000h 0054h 14h 01h LSI Logic SAS1068 Host Adapter
1 - Refresh
b. Press Enter.
4. To update the firmware, use the mptutil command.
5. Reset the controller.
fs0:> reset
The mptutil commands and functions are listed in Table 10 and are described in the following
sections.
Table 10 MPTUTIL Commands and Functions
FunctionCommand
Updating HBA RISC firmware on the controllermptutil -f <firmware_file>
Updating EFI driver on first controllermptutil -o -g <x86_file> <fcode_file>
Viewing VPD informationmptutil -o -vpd -c 0
Parameters in < > are optional. A space is required between command line options and their parameters.
Flashing Firmware on First Controller
To update the HBA RISC firmware on the first controller:
1. At the fs0:> prompt, enter mptutil -f <firmware_file> -c 0.
2. At the fs0:> prompt, enter reset.
The filename is optional and you are prompted for a filename if it is omitted.
Another way to flash the firmware executes without your knowledge. When mptutil is issued,
and a SAS HBA is in any state other than ready or operational, mptutil immediately performs
a firmware download boot. The firmware provided by you to do the firmware download boot is
immediately flashed after the firmware download boot has completed.
The mptutil command does this because the firmware only moves to the operational state if it
is running from flash and not memory. Operational state is needed to do everything else provided
in the utility.
Flashing BIOS and EFI Driver on the First Controller
To update the EFI driver on the first controller:
1. At the fs0:> prompt, enter mptutil -o -g <Bios_File> <EFI_driver_file> -c
0.
2. At the fs0:> prompt, enter reset.
The filename is optional and you are prompted for a filename if it is omitted.
52 Installing the Server Blade Into the Enclosure

HP Integrity BL860c Specifications

General

Brand	HP
Model	Integrity BL860c
Category	Server
Language	English