Hardware options installation 91
•
•
•
Cage nuts
Rack template
Server bezel for rack environment
In addition to the supplied items, you may need a T-15 Torx screwdriver, which
is attached to the rear of the server.
Before converting a tower server to a rack server:
1. Power down the server ("Powering down the server" on page 27
).
2. Remove the front bezel door, if necessary.
3. Remove the access panel ("Removing the access panel" on page 30
).
4. Remove the feet.
5. Remove the tower configuration panel:
a. Use the Torx T-15 screwdriver to remove the two front panel screws.
To Next Page
Loading...
