NOTE:
• When using the HP StorageWorks XP1024/XP128 Disk Array, take the target command
device offline before executing the YKDELCMD command.
• For the following models, you can execute the YKDELCMD command regardless of whether
the target command device is online or offline:
◦ HP StorageWorks XP12000/XP10000 Disk Array
◦ HP StorageWorks XP24000/XP20000 Disk Array
◦ HP StorageWorks P9500 Disk Array
• For the HP StorageWorks XP1024/XP128 Disk Array, you can only delete command devices
registered in storage systems that are directly connected to the host. You cannot delete remote
storage system command devices.
• Take care not to delete command devices defined in the route list.
Route Status Panel (Route Management)
The Route Status panel is displayed when s is specified for the AC column in the Manage Route
panel. The following table shows the Route Status panel when the F11=CCAInfo key is pressed on
the Route Status panel.
F11=CCAInfo keyF10=DADInfo keyItem
DisplayedDisplayedRoute number
List number
Not displayedDAD ID
DisplayedSerial number
Not displayedSSID
CU number
CCA
DisplayedDevice number
Not DisplayedVolume serial number
Figure 88 (page 102) shows the Route Status panel (default display) when the F10=DADInfo key is
pressed.
Manage Route Panel (Route Management) 101
To Next Page
Loading...
