If the number of S-VOL devices selected does not match the number of P-VOL devices, this panel
remains ready to accept device selections until the number matches the number of P-VOL devices.
Once the number of selected devices matches the number of P-VOL devices, display transits to the
Copy Group Pair Detail panel.
You can use the SELECT command in the Pair Selection List (Secondary) panel. For details about
how to use the SELECT command, see “Command Line Commands” (page 11).
You can specify the following fields for a condition of the SELECT command:
TypeValue in fieldName of field
HexadecimalDevice NumberDEVN
Character stringVolume serial numberVOLSER
If you omit the field name, DEVN will be set as a default value.
Sort Copy Group Container Panel
If you press the F6=Sort key in the Copy Group Detail Definition panel, the Sort Copy Group
Container panel for specifying the sorting order for the CG container is displayed.
Figure 80 (page 93) shows the Sort Copy Group Container panel.
Figure 80 Sort Copy Group Container Panel
In the Sort Copy Group Container panel, you can select the sorting order from the following items.
Sort OrderItem
Consistency group ID order.1. C/T Group ID
Subconsistency group ID order.2. sub C/T Group ID
Primary storage system serial number order.3. Primary-Storage System Serial
Number
Secondary storage system serial number order.4. Secondary-Storage System Serial
Number
Order of the arbitration command device (primary storage system)5. Primary Command Device for
Arbitration
Order of the arbitration command device (secondary storage
system)
6. Secondary Command Device for
Arbitration
If you press the F3=Exit key when you change the copy type in the Copy Group Detail Definition
panel, or when the consistency group ID and subconsistency group ID have been changed, the
Confirm Configuration File Update panel (see “Confirm Configuration File Update Panel” (page 180))
is displayed.
Discover/Define Configuration Panel (Configuration File Definition) 93
To Next Page
Loading...
