When you press F12=Cancel in the Path Set Detail panel, the Confirm Cancellation of Editing panel
(see “Confirm Cancellation of Editing Panel” (page 177)) is displayed to confirm that the operation
is to be cancelled without modifying the path set definition file.
In the Path Set Detail panel, you can use the SORT command. For details about how to use the
SORT command, see “Command Line Commands” (page 11).
Edit Logical Path Definition Panel
If e is specified in AC in the Path Set Detail panel, the Edit Logical Path Definition panel appears
where you can edit logical paths.
Figure 54 (page 63) shows the Edit Logical Path Definition panel.
Figure 54 Edit Logical Path Definition Panel
Table 44 (page 63) describes the items in the Edit Logical Path Definition panel.
Table 44 Contents of the Edit Logical Path Definition Panel
DescriptionItem
Path set IDPath Set ID
Type of path
• CU: Inter-CU logical path
• DKC: inter-DKC logical path
Type
Shared attributes for path (modifiable).
• Y— This path has shared attributes.
The path is deleted only if the FORCE parameter is specified when deleting the path.
• N— This path has no shared attributes.
The path is deleted regardless of whether the FORCE parameter is specified when deleting
the path.
SHR
Specify an action.
s: Displays the Select Storage System panel used to select the site from a list of storage
systems.
When actions are entered in multiple AC columns, each is processed in the order displayed.
AC
Discover/Define Configuration Panel (Configuration File Definition) 63
To Next Page
Loading...
