Table 96 Contents of the Confirm Command Device Delete Panel (displayed from Extra
Command Device Direct Operation Panel) (continued)
DescriptionItem
CCA to which the specified command device belongsCCA
APID of the specified command device
For the HP StorageWorks XP1024/XP128 Disk Array, or when APID information cannot
be obtained, N/A is displayed in the APID. In this case, use a 4-digit hexadecimal to
specify the APID of the command device to be deleted, because you cannot perform
deletion processing with N/A displayed.
APID
Pressing the Enter key deletes the command device registered in the storage system. Pressing the
F12=Cancel key cancels the deletion of the command device.
Confirm Configuration File Delete Panel
When deleting a configuration file, the Confirm Configuration File Delete panel appears, prompting
you to confirm whether to perform the deletion.
Figure 141 (page 180) shows the Confirm Configuration File Delete panel.
Figure 141 Confirm Configuration File Delete Panel
Pressing the Enter key deletes the configuration file. Pressing the F12=Cancel key cancels the
deletion of the configuration file.
Confirm Configuration File Update Panel
When you attempt to update a configuration file for the following operations, the Confirm
Configuration File Delete panel is displayed asking you whether you want to perform the update:
• When changing the copy group definition.
• When changing a dummy device number in the disk configuration definition.
• When changing the route list definition.
• When changing the path set definition.
Figure 142 (page 181) shows an example of the Confirm Configuration File Update panel. The
contents displayed in the panel vary depending on the definition to be changed.
180 ISPF Panels
To Next Page
Loading...
