Table 152 Path Set Structure (continued)
DescriptionREXX variables
The number of physical paths from the primary site to the
secondary site set in the storage system (0 to 8)
0Setting
The number of defined physical paths from the secondary
site to the primary site (0 to 8)
0S2P
Status of a logical pathStatus
3
n
The target port number of the primary site of the logical
path (on the storage system indicated by
Pri.SerialNum)
portPri
The initiator port number of the secondary site of the
logical path (on the storage system indicated by
Sec.SerialNum)
portSec
The number of physical paths from the secondary site to
the primary site set in the storage system (0 to 8)
0Setting
1 These variables are valid when the n.type value is DKC.
2 These variables are valid when the n.type value is CU.
3 When the YKLOAD command is executed, values are loaded from the configuration file and set as REXX variables.
When the YKQRYPTH command is executed, REXX variables are updated.
FlashCopy Information Structure
Table 153 (page 348) shows the FlashCopy information structure. The prefix for the name of the
FlashCopy information structure is stem-name-specified-in-STEM-parameter. Each REXX variable is
preceded by a period (.).
Table 153 FlashCopy Information Structure
DescriptionREXX variables
Existence of FlashCopy information structure (Valid)Info
1
Hardware informationState0Source
Hardware informationState1
Hardware informationState2
Hardware informationState3
Hardware informationState4
Hardware informationState5
Hardware informationState6
Hardware informationState7
Existence of a FlashCopy relationship:
• 0: No
• 1: Yes (copying)
State0Target
Existence of a FlashCopy in COPY mode relationship:
• 0: No
• 1: Yes (Copying in COPY mode)
State1
Existence of a FlashCopy in NOCOPY mode relationship:
• 0: No (No FlashCopy in NOCOPY mode)
• 1: Yes (FlashCopy in NOCOPY mode exists)
State2
348 Data Objects