EasyManua.ls Logo

HP StorageWorks P9000 - Executing YKQRYDEV

HP StorageWorks P9000
399 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE: Status displays the execution result of the action specified for AC. If you specify f for AC
and execute the action, out of the devices registered in the disk configuration definition file, all
command devices that are registered in the storage system are displayed in the Command Device
Selection List panel. If you press the F3=Exit key to exit the Command Device Selection List panel,
Status in the Route Status panel displays the processing result of a command device information
query (Fnd,nn).
Executing YKQRYDEV
When q is specified in the AC column in the Route Status panel, the YKQRYDEV command is
executed to display command device information. The Command Device Status panel will be
displayed. This panel will be also displayed when q is specified in the AC column in the Command
Device Selection List panel.
The Command Device Status panel is shown in Figure 90 (page 104) to Figure 92 (page 105).
When registered to a storage system as a command device.
Figure 90 Command Device Status Panel (Command Device is Registered)
While it is defined as a command device, it has not been registered to a storage system as
a command device (the YKBLDCMD command has not been executed), meanwhile it is also
defined as a copy pair.
104 ISPF Panels

Table of Contents

Other manuals for HP StorageWorks P9000

Related product manuals