Table 97 Contents of the Confirm Path Delete Panel
DescriptionItem
Path set IDPath Set ID
Specify whether to set the FORCE parameter when executing the YKDELPTH command
by using the number.
• Delete only non-share paths: Do not specify the FORCE parameter.
• Delete all paths: Specify the FORCE parameter.
Delete Option
Pressing the Enter key deletes the logical path in accordance with the specified value in Delete
Option. Pressing the F12=Cancel key cancels the deletion of the logical path.
Confirm Path Set Load Panel
When you specify b or q in AC of the Manage Path Set panel without executing the YKLOAD
command, the Confirm Path Set Load panel is displayed, requesting the loading of the path set.
Figure 146 (page 183) shows the Confirm Path Set Load panel.
Figure 146 Confirm Path Set Load Panel
Pressing the Enter key loads the path set. Pressing the F12=Cancel key cancels the loading of the
path set.
Confirm Route Delete Panel
If d is specified for AC for the first entry of the route in the Entire Route Information panel, the
Confirm Route Delete panel is displayed to confirm whether to delete the route.
Figure 147 (page 183) shows the Confirm Route Delete panel.
Figure 147 Confirm Route Delete Panel
Confirmation Panels 183
To Next Page
Loading...
