HP StorageWorks P9000 - Ykdemo08

/*
* printErrorMessage: This procedure prints all of the error messages
* in the Message structure when a CLI command failed.
*/
printErrorMessage: procedure expose DEMO_MSG.
do x = 1 to DEMO_MSG.0
say "Severity = " || DEMO_MSG.x.Severity;
say "Text = " || DEMO_MSG.x.Text;
say "Value = " || DEMO_MSG.x.Value;
end;
return 0;
YKDEMO08
/* REXX */
/**********************************************************************/
/* */
/* All Rights Reserved. Copyright (C) 2009, 2010, Hitachi, Ltd. */
/* */
/**********************************************************************/
/* */
/* YKDEMO08 - A sample demonstration script that illustrates */
/* how to use the Business Continuity Manager's CLI commands to */
/* perform fail-over operations in a 2DC configuration with */
/* HyperSwap and UR. */
/* This script can be used when storage system at the primary */
/* site has been stopped for a storage system maintenance or */
/* because a storage system failure has occurred. */
/* */
/* This sample script assumes the following settings: */
/* */
/* 1) The definition files are stored in the dataset with the */
/* prefix "BCM.DEMO". */
/* 2) The TC copy group's copy group ID is MYTCHS. */
/* 3) The copy group ID between the primary and */
/* remote sites is MYUR1. */
/* 4) The copy group ID between the local and */
/* remote sites is MYUR2. */
/* 5) The route list ID is "DEMORLST". */
/* 6) The primary Device Address Domain ID is "PRIM". */
/* */
/* The details for this sample script are as follows: */
/* */
/* 1) Call YKLOAD to load configuration definitions. */
/* 2) Confirm the ready state for operations in 2DC configuration */
/* with HyperSwap and UR. */
/* 3) Watch for the occurrence of a HyperSwap. */
/* 4) Suspend MYUR1. */
/* 5) Execute DeltaResync MYUR2. */
/* */
/**********************************************************************/
/* Sample script begins. */
say "#-- BEGIN YKDEMO08."
address TSO "YKENV"
call "YKLOAD" "STEM(DEMO_INFO.MYTCHS.) PREFIX(BCM.DEMO) GROUP(MYTCHS)",
"DAD(PRIM) MSG(DEMO_MSG.) ROUTE(DEMORLST)"
/*
* Check the return code of YKLOAD.
*/
if result /= 0
then do
Command details 287