YKLOAD Command
Format
YKLOAD
1
STEM(stem-name-1)
1
PREFIX(prefix)
{
1
GROUP(copy-group-id)
1
DAD(dad-id)
1
ROUTE(route-list-id)]|
1
PATH(path-set-id)
1
DAD(dad-id)
1
ROUTE(route-list-id)]]|
1
ROUTE(route-list-id)
1
DAD((dad-id)}
1
MSG(stem-name-2)
Function
This command is an REXX subroutine.
This command loads the configuration file defined in the ISPF panel and creates an REXX variable
structure. The types of REXX variable structures that are created by this command are as follows:
• Copy group structure
• Host-Discovered Array Index structure
• Host-Discovered Array structure
• Route list structure
• Path set structure
Which configuration file is loaded and which REXX variable structure is created depends on the
specified parameters. For details about REXX variable structures, see “About REXX Variable
Structures” (page 323).
Table 121 (page 223) describes which configuration files result in which REXX variable structures
for each parameter.
Table 121 Which File Results in Which REXX Variable Structure
REXX variable structure that is createdLoaded fileSpecified parameter
• Copy group structure
• Host-Discovered Array Index
structure
• Host-Discovered Array structure
• Copy group definition file
• Disk configuration definition file
GROUP
• Route list structure
• Host-Discovered Array Index
structure
• Host-Discovered Array structure
• Disk configuration definition file
• Route list definition file
• Command device definition file
ROUTE
• Host-Discovered Array Index
structure
• Host-Discovered Array structure
• Path set structure
• Disk configuration definition file
• Path set definition file
PATH
Command details 223
To Next Page
Loading...
