Figure 142 Confirm Configuration File Update Panel
If you change the definition in the Copy Group Attributes panel and then press the Enter key, any
required attributes that were not entered in the Copy Group Attributes panel are displayed in a
Warning. When all required attributes have been specified, the Warning is not displayed.
If you have updated the copy group definition file, the disk configuration definition file, the route
list definition file, or the path set definition file, pressing the Enter key updates the file, and pressing
the F12=Cancel key displays the previous panel.
When you execute c in the Manage Path Set panel, pressing the Enter key updates the file, and
pressing the F12=Cancel key cancels the updating of the file. However, after an error occurred
during an update of the configuration file, if you press the F12=Cancel key, the Cancellation
Warning panel is displayed.
When you moved to the Add Copy Group panel by pressing F5=Add in the Copy Group Selection
List panel, if you press F12=Cancel in the Confirm Configuration File Update panel, the display
returns to the Copy Group Selection List panel.
Confirm Copy Group Load Panel
If m or q is specified in the AC in the Manage Copy Groups panel without executing the YKLOAD
command, the Confirm Copy Group Load panel is displayed to request the copy group load.
Figure 143 (page 181) shows the Confirm Copy Group Load panel.
Figure 143 Confirm Copy Group Load Panel
Pressing the Enter key loads the copy group. Pressing the F12=Cancel key cancels the loading of
the copy group.
Confirmation Panels 181
To Next Page
Loading...
Need help?
General