you then press the Enter key with S displayed next to AC, the devices become selected. A similar
operation occurs when you select VOLSER and specify the devices by volume name.
Figure 79 (page 92) shows the Pair Selection List (Secondary) Panel.
Figure 79 Pair Selection List (Secondary) Panel
“Contents of the Pair Selection List (Secondary) Panel” (page 92) describes the items in the Pair
Selection List (Secondary) panel.
Table 63 Contents of the Pair Selection List (Secondary) Panel
DescriptionItem
If the copy pairs to be specified are indicated by device numbers, select this item, and then
specify the device number range for the copy pairs you want to select (as ascending
hexadecimal numbers).
Devn
1
If the copy pairs to be specified are indicated by volume serial numbers, select this item, and
then specify the volume serial number range for the copy pairs that you want to select (in
EBCDIC code order).
Volser
1
Specify s for devices joined in copy pairs. Copy pairs are joined in ascending order of device
number.
AC
• Displays *In Config once a copy pair is joined (once the paired device has been
determined).
• Displays *Imported if the device is imported from the SMS storage group.
Prompts
Volume serial numberVolser
Device numberDevn
Storage system serial numberSN
SSIDSSID
CU numberCU
The two leftmost digits indicate the device CCA (in hexadecimal)
The rightmost digit indicates whether the CCA is an external volume.
• +: External volume
• —: Not an external volume
• (blank): The volume attribute is unknown because it could not be acquired
CCA
1 The procedure to specify the range is the same as for specifying the pattern parameter for the SELECT command. For
details about how to specify the pattern parameter for the SELECT command, see “Command Line Commands”
(page 11).
92 ISPF Panels
To Next Page
Loading...
