Table 73 Contents of the Manage Copy Groups Panel
DescriptionItem
Specify an action.AC
• l: Executes the YKLOAD command to load copy groups.
1
• q: Executes the YKQUERY command to display the copy pair volume status.
• m: Executes the YKMAKE command to create copy pairs.
• u: Executes the YKSUSPND command to suspend copy pairs.
• r: Executes the YKRESYNC command to resynchronize copy pairs.
• d: Executes the YKDELETE command to dissolve copy pairs.
1
• w: Executes the YKWATCH command to monitor the copy pair status change.
• e: Executes the YKEWAIT command to monitor the copy pair status change.
1
• c: Executes the YKRECVER command to dissolve copy pairs from the secondary
site.
• v: Execute the YKQUERY command with the VERIFY parameter specified.
• f: Executes the YKEWAIT command with the TIMEOUT(0) parameter specified.
If there are many copy pairs, you can obtain the volume status more quickly by
specifying f in AC, rather than by specifying q.
2, 3
Copy group IDCopy Group ID
Result of action specified in AC:Status
• NOT LOADED: The copy group has not been loaded.
• LOAD ERROR RC = xx
4
: An error occurred during loading the copy group.
• LOADED WITH WARNINGS RC = xx: The copy group has been loaded with
warning attached.
• LOADED: The copy group has been loaded.
• ESTABLISH ERRORS. YKMAKE RC = xx: making of a copy pair failed.
• ESTABLISHED: making of a copy pair requested.
• ESTABLISHED(HOLD): making of a copy pair with HOLD specified was
requested.
• SUSPEND ERRORS. YKSUSPND RC = xx: suspending of a copy pair failed.
• SUSPENDING: suspending of a copy pair requested.
• RESYNC ERRORS. YKRESYNC RC = xx: synchronizing of a copy pair failed.
• RESYNC PENDING: pending of the synchronizing of a copy pair requested.
• QUERY ERRORS. YKQUERY RC = xx: acquiring a copy pair status failed.
• QUERY ERRORS. YKEWAIT RC = xx: acquiring a copy pair status failed.
• QUERIED SUCCESSFULLY: copy pair status was acquired.
• DISSOLVE ERRORS. YKDELETE RC = xx: dissolving a copy pair failed.
• PAIRS DISSOLVED: dissolving a copy pair requested.
• EWAIT ERRORS. YKEWAIT RC = xx: monitoring volume status failed.
• EWAIT GOTO(status
5
) SUCCESSFULLY: The volume has moved to the specified
volume status.
• RECOVER ERRORS. YKRECVER RC = xx: an attempt to dissolve the copy pair
from the secondary site has failed.
• RECOVER SUCCESSFULLY: a request was made to dissolve the copy pair from
the secondary site.
1 An error occurs if an attempt is made to load a copy group definition file that was not created by Business Continuity
Manager.
2 The following list describes the differences between specifying q and f in AC:
Manage Copy Groups Panel (Copy Group Operation) 117
To Next Page
Loading...
