Table 100 (page 189) shows the configuration files that must be loaded in an environment that does
not contain a Non Gen'ed volume and where the following conditions exist:
• The P-VOL is recognized by the host.
• The copy type parameter is CA, CAA or CAJ, and the host does not recognize the S-VOL.
• The copy type parameter is BC, and the host recognizes the S-VOL.
Table 101 (page 190) shows the configuration files that must be loaded in an environment that
contains a Non Gen'ed volume and where the following conditions exist:
• The copy type parameter is CAJ, and the host does not recognize the P-VOL (remote storage
system) or the S-VOL (Non Gen'ed volume).
• The copy type parameter is BC, and the host does not recognize the P-VOL (Non Gen'ed
volume) but recognizes the S-VOL.
Table 100 Configuration Files That Must Be Loaded Before Command Execution (When the
Environment Does Not Contain a Non Gen'ed Volume)
Configuration file that must be loadedCommand name
Path set definition fileRoute list definition fileCopy group definition file
--Y--YKBLDCMD
YD
1
--YKBLDPTH
------YKCONMSG
--Y--YKDELCMD
--D
2
YYKDELETE
YD
1
--YKDELPTH
------YKDROP
------YKENV
------YKERCODE
--D
2, 3, 4
YYKEWAIT
------YKEXPORT
------YKFCSTAT
--YYYKFREEZE
------YKH2B
------YKIMPORT
------YKINSCHK
--D
2, 4
YYKMAKE
------YKQHPATH
--D
3
--YKQRYDEV
YD
1
--YKQRYPTH
--D
3, 4
YYKQUERY
--YYYKRECVER
--D
2, 5
YYKRESYNC
--YYYKRUN
Configuration Files That Must Be Loaded Before Command Execution 189
To Next Page
Loading...
