EasyManua.ls Logo

HP StorageWorks P9000

HP StorageWorks P9000
399 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
then do
call printErrorMessage;
exit;
end;
else
nop;
/*
* Print the information in the command device in the primary
* storage system.
* Refer to the Business Continuity Manager Reference Guide for the
* full details about information items available by YKQRYDEV.
*/
say "-------------------------------------";
say "CDEV(Primary) DKC's SSID = " || DEMO_CDEVP.SSID;
say "CDEV(Primary) is valid? = " || DEMO_CDEVP.Cdev.Info;
say "CDEV(Primary) is status = " || DEMO_CDEVP.Cdev.Status;
say "CDEV(Primary)'s APID = " || DEMO_CDEVP.Cdev.APID;
say "-------------------------------------";
/*
* The following example retrieves the information about the command
* device in the secondary storage system.
* The information is stored under "DEMO_CDEVS" as specified by the
* STEM parameter.
* The following code shows one way to use YKQRYDEV with SN, CU, and
* CCA parameters, such as follows:
* "SN(12345) CU(10) CCA(20)"
*/
address TSO "YKQRYDEV STEM(DEMO_CDEVS.) SN(#####) CU(##) CCA(##)",
"MSG(DEMO_MSG.)";
/*
* Check the return code to see if it is 0 or not.
*/
if rc /= 0
then do
call printErrorMessage;
exit;
end;
else
nop;
/*
* Print the information in the command device in the secondary
* storage system.
*/
say "-------------------------------------";
say "CDEV(Secondary) DKC's SSID = " || DEMO_CDEVS.SSID;
say "CDEV(Secondary) is valid? = " || DEMO_CDEVS.Cdev.Info;
say "CDEV(Secondary) is status = " || DEMO_CDEVS.Cdev.Status;
say "CDEV(Secondary)'s APID = " || DEMO_CDEVS.Cdev.APID;
say "-------------------------------------";
/*
* Delete the command device in the secondary storage system.
* Note that the secondary command device is deleted first. This is
* because YKDELCMD command should be sent to the secondary site. If
* the primary command device was deleted first, there is no way for
* BC Manager to send the command to the secondary command device.
* The following code shows one way to use YKDELCMD with SN, CU, CCA
* and APID parameters, such as follows:
* "SN(12345) CU(10) CCA(20) APID(5613)"
274 CLI Commands

Table of Contents

Other manuals for HP StorageWorks P9000

Related product manuals