HP StorageWorks P9000 - Page 340

Table 151 Device Information Structure (continued)
DescriptionREXX variables
ATTIME suspend status
• Notset: The ATTIME suspend time is not set.
• PRESET: The ATTIME suspend time is set, but
suspend has not been performed.
• SUSPEND (TIMESTAMP): Suspend was
performed because the ATTIME suspend time
elapsed.
• SUSPEND (TIMEOUT): Suspend was
performed because a timeout occurred.
Status
4
Number of copy pairs in the C/T groupPairCt
4
Number of suspended copy pairsSuspendOpCt
4
Number of suspending copy pairsTransCt
4
Number of failure suspended copy pairsSuspendErCt
4
Time remaining until timeout (minutes)Trem
4
Number of BC copy pairs (0 to 3)0BC
Status of BC copy pair
• PENDING (01)
• DUPLEX (02)
• TRANS (03)
• SUSPOP (04)
• PENDING (05)
• SUSPER (06)
• SUSPVS (07)
• REVRSY (08)
• TRANS (09)
Staten
Protect mode
• PROTECT
• PERMIT
ProtectMode
Copy pace
• SLOW
• NORMAL
InitPace
Copy pair matching rateMatchingPerCent
SSID of P-VOLSSIDPri
Storage system serial number of P-VOLSerialnum
CU number of P-VOLCUNum
CCA of P-VOLCCA
SSID of S-VOLSSIDSec
Storage system serial number of S-VOLSerialnum
CU number of S-VOLCUNum
CCA of S-VOLCCA
340 Data Objects