When there are multiple copy pair statuses in a copy group
If there are multiple copy pair statuses in a copy group, one of the copy pair statuses is used as
the copy group status to be monitored. If there is a copy pair with one of the high priority levels
shown in the table below, that copy pair status is used for the copy group. For example, if there
are no copy pairs in the INVALID status, but there is a copy pair in the SUSPER status, then the
corresponding copy group is treated as being in the SUSPER status. If there are no copy pairs in
the INVALID or SUSPER status, but there is a copy pair in the NODELTA status, then the
corresponding copy group is treated as being in the NODELTA status.
Table 167 Copy Pair Status Priority
Copy pair statusPriority
INVALID1
CONSLOST2
SUSPER3
NODELTA4
HOLDER5
SUSPCU6
SIMPLEX7
PENDING8
TRANS9
HOLDTRNS10
REVRSY11
SUSPVS12
SUSPOP13
HOLD14
SWAPPING15
DUPLEX16
YKMONCG File 375
To Next Page
Loading...
