● Backlight cable (ZIF) (6)
● NFC module cable (ZIF) (7)
● Keyboard cable (ZIF) (8)
● RTC battery cable (9)
● Fingerprint reader cable (ZIF) (10)
● Wireless antenna cables (11)
2. Remove the two Phillips M2.0 × 4.0 screws (1) that secure the I/O bracket to the computer.
3. Remove the two Phillips M2.0 × 5.0 screws (2) that secure the RJ-45 (network) door to the computer.
4. Remove the three Phillips M2.0 × 2.5 screws (3) that secure the system board to the computer.
5. Remove the I/O bracket (4).
The I/O bracket is included in the Bracket Kit, spare part number M21855-001.
6. Remove the RJ-45 (network) door (5). The door is available in the Plastic Kit as spare part number
N06911-001.
7. Lift the right edge of the system board (1) until it rests at an angle.
56
Chapter 5 Removal and replacement procedures for authorized service provider parts
To Next Page
Loading...
