HPE FlexFabric 5940 SERIES

10
Table 3 Command output
Field Description
Interface Interface to which the ACL applies.
Inbound policy ACL used for filtering incoming traffic.
Outbound policy ACL used for filtering outgoing traffic.
IPv4 ACL 2001 IPv4 basic ACL 2001 has been successfully applied.
IPv4 ACL 2002 (Failed) The device has failed to apply IPv4 basic ACL 2002.
Hardware-count ACL rule match counting has been successfully enabled.
Hardware-count (Failed) The device has failed to enable counting ACL rule matches.
From 2011-06-04 10:25:21 to
2011-06-04 10:35:57
Start time and end time of the statistics.
2 packets
Two packets matched the rule.
This field is not displayed when no packets matched the rule.
No resource
Resources are not enough for counting matches for the rule. In packet
filtering statistics, this field is displayed for a rule when resources are
not sufficient for rule match counting.
rule 5 permit source 1.1.1.1 0
(Failed)
The device has failed to apply rule 5.
Totally 2 packets permitted, 0
packets denied
Number of packets permitted and denied by the ACL.
Totally 100% permitted, 0%
denied
Ratios of permitted and denied packets to all packets.
IPv4 default action
Packet filter default action for packets that do not match any IPv4
ACLs:
• Deny—The default action deny has been successfully applied for
packet filtering.
• Deny (Failed)—The device has failed to apply the default action
deny for packet filtering. The action permit still functions.
• Permit—The default action permit has been successfully applied
for packet filtering.
IPv6 default action
Packet filter default action for packets that do not match any IPv6
ACLs:
• Deny—The default action deny has been successfully applied for
packet filtering.
• Deny (Failed)—The device has failed to apply the default action
deny for packet filtering. The action permit still functions.
• Permit—The default action permit has been successfully applied
for packet filtering.
MAC default action
Packet filter default action for packets that do not match any Layer 2
ACLs:
• Deny—The default action deny has been successfully applied for
packet filtering.
• Deny (Failed)—The device has failed to apply the default action
deny for packet filtering. The action permit still functions.
• Permit—The default action permit has been successfully applied
for packet filtering.
Totally 7 packets The default action has been executed on seven packets.