159
Portal Web server: Not configured
Authentication domain: Not configured
Bas-ipv6: Not configured
User detection: Not configured
Action for server detection:
Server type Server name Action
-- -- --
Layer3 source network:
IP address Prefix length
Destination authenticate subnet:
IP address Prefix length
A user can perform portal authentication by using the HPE iNode client or a Web browser. Before
passing the authentication, the user can access only the authentication page
http://192.168.0.111:8080/portal and all Web requests will be redirected to the authentication page.
After passing the authentication, the user can access Internet resources.
# After the user passes authentication, use the following command to display information about the
portal user.
[SwitchA] display portal user interface vlan-interface 4
Total portal users: 1
Username: abc
Portal server: newpt
State: Online
Authorization ACL: None
VPN instance: --
MAC IP VLAN Interface
0015-e9a6-7cfe 8.8.8.2 4 Vlan-interface4
Configuring extended direct portal authentication
Network requirements
As shown in Figure 55, the host is directly connected to the switch (the access device). The host is
assigned with a public IP address either manually or through DHCP. A portal server acts as both a
portal authentication server and a portal Web server. A RADIUS server acts as the
authentication/accounting server.
Configure extended direct portal authentication. If the host fails security check after passing identity
authentication, it can access only subnet 192.168.0.0/24. After passing security check, the host can
access Internet resources.
To Next Page
Loading...
Need help?
General