HPE FlexNetwork 5510 HI Series

40
Configuring LDAP schemes
Configuration task list
Tasks at a glance
Configuring an LDAP server:
• (Required.) Creating an LDAP server
• (Required.) Configuring the IP address of the LDAP server
• (Optional.) Specifying the LDAP version
• (Optional.) Setting the LDAP server timeout period
• (Required.) Configuring administrator attributes
• (Required.) Configuring LDAP user attributes
(Required.) Creating an LDAP scheme
(Required.) Specifying the LDAP authentication server
(Optional.) Displaying and maintaining LDAP
Creating an LDAP server
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Create an
LDAP server
and enter LDAP server
view.
ldap server
server-name By default, no LDAP server exists.
Configuring the IP address of the LDAP server
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter LDAP server view.
ldap server
server-name N/A
3. Configure the IP address of
the LDAP server.
{
ip
ip-address |
ipv6
ipv6-address } [
port
port-number ] [
vpn-instance
vpn-instance-name ]
By default, an LDAP server has no
IP address.
You can configure either an IPv4
address or an IPv6 address for an
LDAP server. The most recent
configuration takes effect.
Specifying the LDAP version
Specify the LDAP version on the NAS. The device supports LDAPv2 and LDAPv3. The LDAP
version specified on the device must be consistent with the version specified on the LDAP server.
To specify the LDAP version:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter LDAP server view.
ldap server
server-name N/A
3. Specify the LDAP version.
protocol-version
{
v2
|
v3
}
By default, LDAPv3 is used.
A Microsoft LDAP server supports
only LDAPv3.