455
Configuring parameters for a user profile
Configurations in user profile view take effect only after the device applies the user profile to the user.
Configuring QoS parameters for traffic management
To configure QoS parameters:
1. Enter system view.
system-view
N/A
2. Enter user profile view.
user-profile
profile-name N/A
3. Apply a QoS policy.
qos apply policy
policy-name
{
inbound
|
outbound
}
T
he QoS policy must already
exist.
For information about QoS policy
configuration, see ACL and QoS
Configuration Guide.
For information about the
commands, see ACL and QoS
Command Reference.
Displaying and maintaining user profiles
Execute display commands in any view.
Display configuration and online user information
for the specified user profile or all user profiles.
display user-profile
[
name
profile-name ] [
slot
slot-number ]
User profile configuration examples
Local 802.1X authentication/authorization with QoS policy
configuration example
Network requirements
As shown in Figure 137, the access switch performs local 802.1X authentication and authorization
for User A, User B, and User C.
Configure user profiles for the users and apply a QoS policy to each user to implement the following
functions:
• Deny User A's access to the network from 8:30 to 12:00 daily.
• Limit the outgoing traffic rate to 2000 kbps for User B.
• Limit the incoming traffic rate to 4000 kbps for User C.
To Next Page
Loading...
Need help?
General