412
• ARP blackhole routing—Creates a blackhole route destined for an unresolved IP address.
The device drops all matching packets until the blackhole route is deleted. A blackhole route is
deleted when its aging timer (25 seconds) is reached or the route becomes reachable.
After a blackhole route is created for an unresolved IP address, the device immediately starts
the first ARP blackhole route probe by sending an ARP request. If the resolution fails, the
device continues probing according to the probe settings. If the IP address resolution succeeds
in a probe, the device converts the blackhole route to a normal route. If an ARP blackhole route
ages out before the device finishes all probes, the device deletes the blackhole route and does
not perform the remaining probes.
This feature is applicable regardless of whether the attack packets have the same source
addresses.
Configuring ARP source suppression
1. Enter system view.
system-view
N/A
2. Enable ARP source suppression.
arp source-suppression
enable
By default, ARP source suppression is
disabled.
3.
Set the maximum number of
unresolvable packets that the
device can receive from a host
within 5 seconds.
arp source-suppression
limit
limit-value
By default, the maximum number is
10.
Configuring ARP blackhole routing
1. Enter system view.
system-view
N/A
2. Enable ARP blackhole routing.
arp resolving-route enable
By default, ARP blackhole routing
is enabled.
3. (Optional.) Set the
interval at
which the device probes ARP
blackhole routes.
arp resolving-route
probe-interval
interval
The default setting is 1 second.
4. (Optional.) Set the number of
ARP blackhole route probes for
each unresolved IP address.
arp resolving-route
probe-count
count
The default setting is one probe.
Displaying and maintaining unresolvable IP attack protection
Execute display commands in any view.
Display ARP source suppression configuration
information.
display arp source-suppression
To Next Page
Loading...
Need help?
General