HPE FlexNetwork 5510 HI Series Security Configuration Guide

15
No.
Attribute
Description
45 Acct-Authentic
Authentication method used by the user. Possible values include:
• 1—RADIUS.
• 2—Local.
• 3—Remote.
60 CHAP-Challenge
CHAP challenge generated by the NAS for MD5 calculation during CHAP
authentication.
61 NAS-Port-Type
Type of the physical port of the NAS that is authenticating the user.
Possible values include:
• 15—Ethernet.
• 16—Any type of ADSL.
• 17—Cable. (With cable for cable TV.)
• 19—WLAN-IEEE 802.11.
• 201—VLAN.
• 202—ATM.
If the port is an ATM or Ethernet one and VLANs are implemented on it,
the value of this attribute is 201.
79 EAP-Message
Used to encapsulate EAP packets to allow RADIUS to support EAP
authentication.
80
Message-Authenticato
r
Used for authentication and verification of authentication packets to
prevent spoofing Access-Requests. This attribute is present when EAP
authentication is used.
87 NAS-Port-Id String for describing the port of the NAS that is authenticating the user.
RADIUS subattributes (vendor ID 25506)
No.
Subattribute
Description
1 Input-Peak-Rate Peak rate in the direction from the user to the NAS, in bps.
2 Input-Average-Rate Average rate in the direction from the user to the NAS, in bps.
3 Input-Basic-Rate Basic rate in the direction from the user to the NAS, in bps.
4 Output-Peak-Rate Peak rate in the direction from the NAS to the user, in bps.
5 Output-Average-Rate Average rate in the direction from the NAS to the user, in bps.
6 Output-Basic-Rate Basic rate in the direction from the NAS to the user, in bps.
15 Remanent_Volume
Total amount of data available for the connection, in different units for
different server types.
20 Command
Operation for the session, used for session control. Possible values
include:
• 1—Trigger-Request.
• 2—Terminate-Request.
• 3—SetPolicy.
• 4—Result.
• 5—PortalClear.
24 Control_Identifier
Identification for retransmitted packets. For retransmitted packets from
the same session, this attribute must be
the same value. For
retransmitted packets from different sessions, this attribute does not
have to be the same value. The client response of a retransmitted
packet must also include this attribute and the value of this attribute
must be the same.
For Accounting-Request packets of the start, stop, and interim update

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English