HPE FlexNetwork 5510 HI Series Security Configuration Guide

27
The device reports online user traffic statistics in accounting packets. The traffic measurement units
are configurable, but they must be the same as the traffic measurement units configured on the
RADIUS accounting servers.
To set the username format and the traffic statistics units for a RADIUS scheme:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter RADIUS scheme
view.
radius scheme
radius-scheme-name
N/A
3. Set the format for
usernames sent to the
RADIUS servers.
user-name-format
{
keep-original
|
with-domain
|
without-domain
}
The default setting depends on the type of
the startup configuration:
•
If the device starts up with initial
settings, the ISP domain name is
included in a username.
• If the device starts up with the factory
defaults
, the ISP domain name is
included in a username except for
the predefined RADIUS scheme
named system. When the username
is sent to a RADIUS server in the
system scheme, the ISP domain
name is removed.
For more information about the startup
configuration, see Fundamentals
Configuration Guide.
4. (Optional.) Set the data
flow
and packet
measurement units for
traffic statistics.
data-flow-format
{
data
{
byte
|
giga-byte
|
kilo-byte
|
mega-byte
} |
packet
{
giga-packet
|
kilo-packet
|
mega-packet
|
one-packet
} }
*
By default, traffic is counted in bytes and
packets.
Setting the maximum number of RADIUS request transmission attempts
RADIUS uses UDP packets to transfer data. Because UDP communication is not reliable, RADIUS
uses a retransmission mechanism to improve reliability. A RADIUS request is retransmitted if the
NAS does not receive a server response for the request within the response timeout timer. For more
information about the RADIUS server response timeout timer, see "Setting RADIUS timers."
You can set the maximum number for the NAS to retransmit a RADIUS request to the same server.
When the maximum number is reached, the NAS tries to communicate with other RADIUS servers in
active state. If no other servers are in active state at the time, the NAS considers the authentication
or accounting attempt a failure.
To set the maximum number of RADIUS request transmission attempts:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter RADIUS scheme view.
radius scheme
radius-scheme-name
N/A
3.
Set the maximum number of
RADIUS request transmission
attempts.
retry
retry-times The default setting is 3.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English