11. Do one of the following:
• Install the air bale.
• Perform steps 9–13 of “
Installing a midplane 4 LFF SAS/SATA drive cage”.
12.
Install the access panel.
13.
Install the server into the rack.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
16.
Power up the server.
The installation is complete.
Memory options
IMPORTANT: This server does not support mixing LRDIMMs and RDIMMs. Attempting to mix any combination of
these DIMMs can cause the server to halt during BIOS initialization. All memory installed in the server must be of
the same type.
DIMM-processor compatibility
The installed processor determines the type of DIMM that is supported in the server:
AMD EPYC processors support DDR4-3200 DIMMS.
Mixing DIMM types is not supported. Install only the supported DDR4-3200 DIMMs in the server.
DIMM population information
For specific DIMM population information, see the DIMM population guidelines on the Hewlett Packard Enterprise website
(https://www.hpe.com/docs/amd-population-rules).
Hardware options installation
93
To Next Page
Loading...
