HPE ProLiant DL385 Gen10 Plus

The installation is complete.
Installing a front 8 SFF SAS/SATA drive cage in box 2
Prerequisites
Before you perform this procedure, make sure that you have the following items available:
• T-10 Torx screwdriver
• The components included with the hardware option kit
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3.
Do one of the following:
•
Extend the server from the rack.
•
Remove the server from the rack.
4.
Remove the access panel.
5.
Remove the air bale.
6.
Remove the fan cage.
7.
Remove the bay blank.
8. Install the 8 SFF front drive cage option.
Hardware options installation
67